Application of gap slicer in actual operation

The application of the gap slicer in the practical operation, we may not know the function of the gap slicer very well, and we are not completely sure of its operation process, so it is so unfamiliar. Therefore, this article not only mentions the usefulness of the gap type slicer, but also briefly summarizes the correct operation steps of the gap type slicer.

1. Practical application of gap slicer in occupation

In occupations such as chemical and pharmaceutical industries, the use of gap slicers is very common, because it can perform cold and heat exchanges with the high-speed running roller surface in high-temperature liquids, so that the high-temperature liquid can be transformed into The flaky solid meets the needs of industrial production.

2. Check the equipment of the operation steps of the gap type slicer

The gap slicer not only has good performance, but also is quite convenient to operate. It only needs to adopt the appropriate process according to the corresponding material characteristics. But no matter how the operation is done, it is the same at the beginning, and a detailed inspection of the gap slicer is required. The content to be checked includes whether the gap slicer is normal, whether it is installed in place, whether the position of each part is accurate, and so on.

3. Connection and adjustment of the operating steps of the gap slicer

When everything is normal, connect the port of the gap slicer to the pipe of the material, and install a valve regulator on the feeding pipe; and connect the water cooling joints on both sides according to the direction of water inlet and outlet. .

Then you can press the power on button of the gap slicer according to the instructions of the electrical cabinet, then adjust the frequency converter, and observe the operating status of the equipment. At the same time, don't forget that the gap between the slicer knife and the roller should be adjusted to ensure that the required slice thickness can be achieved.

The specific operation is also the same. You need to connect the power and water source of the gap type microtome first, and then select the corresponding clamp according to the diameter of the core sample, clamp the core sample and turn it to the center of the chassis, then tighten the clamp; loosen the upper 、Tighten the hand wheel downward, turn the lifting hand wheel, and stop when the end face of the grinding wheel is 1mm from the end face of the core sample.

Then tighten the handle of the gap type slicer, open the water inlet valve to pass water, and close the power switch; then roll the hand wheel counterclockwise, and roll the hand wheel clockwise together to lower the grinding head. When the end face of the grinding wheel touches the end face of the sample, swing the grinding head to grind until the end face of the sample is smoothed, so that the entire slicing operation is completed.